Consumer
Products
Avent DECT baby monitor

Avent DECT baby monitor

SCD496/00

Troubleshooting

Why do the baby unit´s ON light and the parent unit´s LINK light not come on when I press the on/off buttons?

The parent unit has no batteries or is not connected to the mains.
Replace the batteries or connect the device to the mains, using the included adapter with the small plug. Press the on/off button to establish a connection with the baby unit.

The baby unit has no batteries or is not connected to the mains.
Replace the batteries or connect the device to the mains, using the included adapter with the large plug. Press the on/off button to establish a connection with the parent unit.

The baby unit and the parent unit may out each other's range.
Move the parent unit closer to the baby unit, but no closer than 1 metre/ 3 feet.

If the LINK light on the parent unit still does not flash, you need to restore the units' default settings.
Proceed as follows to reset the units:

  • Press and hold the on/off button to switch on the device.
  • Immediately press the volume down button and hold it until the message ¨Reset¨ appears on the display.

The information on this page applies to the following models: SCD496/00 , SCD497/00 , SCD499/00 .

Not what you are looking for?

Did we answer your question?

If not, contact us.